Technical Articles

(800) 622-0828 (US, CA)
(325) 235-5494
(325) 235-4672

To search products by model number, enter "m..."
(Ex: Enter "m3" to search for Model 3.)

Health Physics Medical Physics Metal Recycling Monitoring Systems Emergency Response

Documents

Over the years, Ludlum Measurements has written several technical articles in support of our products. These articles cover topics such as troubleshooting and repair tips, calibration techniques, and other information related to radiation detection and instrumentation.

If you are new to using analog radiation detection instruments, this how-to guide will teach you how to read the meter properly.

Knowing how to read the meter dial is very important for accurate measurements since the meter reading depends not only on where the needle is pointed but also which multiplier or range is selected.

This article provides an overview of the Lumic 1 Calibration Software, a useful tool that provides the ability to read and write important parameters via a USB port in the Model 3000 Series and Model 30 family of instruments.

From time to time, we get phone calls from end users of LMI instruments who have questions about check sources that are optional accessories with our instruments. Many of you are familiar with check sources, what they are and how they are used; however, for those of you who are not, here is a short explanation.

In the event that it becomes necessary to disinfect one of our instruments or detectors, please use following the guidelines.

At some point you may wish to use a different detector with your survey meter than the detector the instrument was originally calibrated with. Unfortunately, this can cause issues because not all detectors operate at the same high voltage or use equivalent meter scales. Using a survey meter and a detector that have not been configured to be used together can lead to inaccurate radiation measurements.

One of the most common service problems is the maladjustment of the detector high voltage setting. We receive many calls from users who have attempted to trouble-shoot their instrument with a "high Impedance" voltmeter. This usually results with the problem of not being able to adjust the high voltage above 450 V. The reason for this problem is the "high impedance" voltmeter typically has an 11 MΩ output impedance and will overload on resistive loads below 60 MΩ.

Many of our customers inquire about the procedure we use to check the operating voltage of scintillation or proportional type detectors. We call this process “to run a plateau”. Hopefully, the following will help to answer a few of these questions.

Occasionally, you may encounter problems with your LMI instrument or detector that may be repaired or resolved in the field, saving turnaround time and expense in returning the instrument to us for repair. Toward that end, LMI electronics technicians offer the following tips for troubleshooting the most common problems. Where several steps are given, perform them in order until the problem is corrected. You should keep in mind that the three most common problems are: 1. detector cables, 2. sticky meters, 3. battery contacts.