Software Downloads

Last Updated November 7, 2017

 

 

 

Software Downloads

 

 

Model 9DP Pressurized Ion Chamber

 

Model 464 Software

 

Model 730 Series MCA Software

 

Model 2200/2000 Software

 

Model 2241 Series Software

  • Version 1.2.1 - PC Logger software. (Note: Not compatible with ASCII Output firmware)
  • Version 1.2.0 - PC Calibrator software. (Note: Not compatible with ASCII Output firmware)
  • RS-232 Data Output PDF - Document detailing the RS-232 data output for various firmware versions.

 

Model 2350 Software

 

Model 2360 Software

 

Model 2360-8 Software


Model 2363 Software

 

Model 3000 Series (includes Model 3000, 3001, 3002, 3019, and 3276)

  • located on the Downloads tab on the specific instrument page

 

Model 3030/3030E Software

 

Model 3030P Software

 

Model 4304 Software

  • Version 1.2.0 - Single Quad Counter software set operating parameters, starts/stops counts, sets operating parameters and runs calibration routines.

 

Model 4525 Software


Model 4609-3 Software

 

Model 4612 Software/Firmware
The Model 4612 counter is a twelve detector SCA (Single Channel Analyzer) with PC control of all necessary operating parameters. Programming the host board requires the Analog Devices Windows Serial Downloader application. To update the host firmware:

  1. Download the Windows Serial Downloader software and the appropriate .HEX file below. Right click on the firmware link and select "Save As" to download the .HEX file.
  2. Disconnect power to the Model 4612 Counter.
  3. Unscrew the host board and locate the 2-pin debug connector next to the EMUL connector.
  4. Place a jumper on the debug connector and insert the host board back into the chassis.
  5. Reconnect power.
  6. Run the Windows Serial Downloader application.
  7. Click the Configuration button and select to correct Serial Port. Click OK.
  8. Click the download button and select the .HEX file. The host board should now be flashed.
  9. Disconnect power to the Model 4612 Counter.
  10. Remove the jumper from the host board and screw it back to the chassis.

Host Board Firmware

  • 34413N02 - Requires Software 1370-081 - Shipping on all new instruments.
  • 34403N11 - Requires Software 1370-045

Software
There are two versions of the software depending on the host firmware.

  • 1370-081 - Latest version of software. Requires firmware version 34413N02 or higher.
  • 1370-045 - Requires firmware version 34403N11 or earlier .

 

Model 4906 Series Software/Firmware